AGM-65A Maverick - Orginal File 3D Model

Specification:
- Brand: AMS
- Scale: 1/10
- Type of product: Arms and weapons
- Recommended Use: Scale Model

Missile Model Dimension:
- Length: 250mm
- Diameter: 30mm
- Wingspan: 72mm
- Width: 50mm

Note:
- Details are considered appropriate to the scale of the model.
- Native software: SolidWork 2020
- Categorized layers
- Open layers
- Ability to Change the Scale
- Ability to Edit Details

Product files:
- AGM-65A-Orginal-Sc10.SLDPRT. (Solidwork)
- AGM-65A-Orginal-Sc10-Decal.SLDPRT. (Solidwork)
- AGM-65A-Rack-Sc10.SLDPRT. (Solidwork)
- Decal File (Open Layers-DPI 600-Size A6). (PDF)
- Decal Manual. (PDF)
- Decal Folder-Textures. (RAR/ZIP)

Description:
The AGM-65 Maverick is an air-to-ground missile (AGM) designed for close air support. It is the most widely produced precision-guided missile in the Western world, 

and is effective against a wide range of tactical targets, including armor, air defenses, ships, ground transportation and fuel storage facilities.

Development began in 1966 at Hughes Aircraft Company as the first missile to use an electronic contrast seeker. It entered service with the United States Air Force in 

August 1972. Since then, it has been exported to more than 30 countries and is certified on 25 aircraft.The Maverick served during the Vietnam, Yom Kippur, Iran–Iraq, 

and Persian Gulf Wars, along with other smaller conflicts, destroying enemy forces and installations with varying degrees of success.

Since its introduction into service, numerous Maverick versions had been designed and produced using electro - optical, laser, and imaging infrared guidance 

systems.The AGM-65 has two types of warhead: one has a contact fuze in the nose, the other has a heavyweight warhead fitted with a delayed-action fuze, 

whichpenetrates the target with its kinetic energy before detonating. The missile is currently produced by Raytheon Missiles & Defense.

The Maverick shares the same configuration as Hughes' AIM-4 Falcon and AIM-54 Phoenix, and measures more than 2.4 m (8 ft) in length and 30 cm (12 in) in 

diameter.

3D printing settings

Note:
It is better to use the resin and settings recommended by your 3D printer company.